Difference between revisions of "Sugar on a Stick/ZyX-LiveInstaller"

From Sugar Labs
Jump to navigation Jump to search
(better place than the soas05 page)
(No difference)

Revision as of 23:10, 7 December 2009

ZyX-LiveInstaller

  • ZyX-LiveInstaller allows you to install SoaS when it is already running from either a LiveUSB device or LiveCD media to a system or external disk. This results in what is considered a traditional operating system installation on disk (or USB-Stick/SD-Card). This is unlike the above methods which create a Live Media (USB/SD) from the .iso file. Please note, this is NOT a method to create a SugarOnAStick LiveUSB. This is a method to
  • To use
  • understand that this is a fairly new piece of open source software, that will overwrite entire partitions or disks ** as well as your bootloader ** during installation. In this release of SoaS, it is intended only for users that are familiar with the risks and possible complications of installing a Linux distribution to system disk.
  • boot your SugarOnAStick
  • start the terminal activity, type in lowercase 'zyx-liveinstaller', then press enter.
  • start the partitioner 'gparted' if necessary
  • you will need at least a single partition for the root filesystem, that is greater than 2GB. Some disks labeled and sold as 2GB may not be quite large enough.
  • Create a seperate partition for the /boot filesystem
  • optionally, you may select a seperate partition for swap space. 1-2GB is recommended and will allow the use of hibernation (suspend-to-disk)
  • note: formatting in the partitioner is not required.
  • exit the partitioner by hitting the X in the top corner of window.
  • read and follow the simple wizard, choosing destination volumes/partitions for boot, root, and swap. ( swap is optional).
  • This is a *destructive* install, meaning that the contents of the disks or partitions you choose will be overwritten entirely.
  • During installation, you are free to use other activities.
  • After installation completes, you may remove the LiveUSB or LiveCD, and continue using the newly installed system - without rebooting!!!. This means that anything done with the system before, during, or after installation persists into the installed system.