Activities/Turtle Art/Using Turtle Art Sensors: Difference between revisions
Tonyforster (talk | contribs) No edit summary |
Tonyforster (talk | contribs) |
||
| Line 19: | Line 19: | ||
For the XO1, the addition of a 150k ohm series resistor would (I expect, no guarantee) give a reduced sensitivity in voltage mode (0-4V) but allow inputs to +- 100V without damage. Input impedance in resistance, volume and pitch modes is much lower but a 1k ohm series resistor should still allow inputs to +-12V. | For the XO1, the addition of a 150k ohm series resistor would (I expect, no guarantee) give a reduced sensitivity in voltage mode (0-4V) but allow inputs to +- 100V without damage. Input impedance in resistance, volume and pitch modes is much lower but a 1k ohm series resistor should still allow inputs to +-12V. | ||
If applying an external voltage to the XO1, it is highly recommended that test leads be made up with a microphone plug and an inbuilt series resistor. | If applying an external voltage to the XO1, it is highly recommended that test leads be made up with a microphone plug and an inbuilt series resistor. 680 ohms is the suggested resistor value, it gives a reasonable input range while still allowing the use of the full resistance range of the XO1. | ||
[[File:Audio 680 ohm.jpg]] | [[File:Audio 680 ohm.jpg]] | ||