2,486
edits
Changes
Activities/Turtle Art/Using Turtle Art Sensors (view source)
Revision as of 18:43, 26 February 2011
, 18:43, 26 February 2011→Pyroelectric alarm with photo
IT IS RECOMMENDED THAT A SERIES PROTECTION RESISTOR BE BUILT INTO THE MICROPHONE PLUG AND LEADS WHEN USING AN EXTERNAL VOLTAGE SOURCE
IT IS RECOMMENDED THAT A SERIES PROTECTION RESISTOR BE BUILT INTO THE MICROPHONE PLUG AND LEADS WHEN USING AN EXTERNAL VOLTAGE SOURCE
The pyroelectric sensor is activated when you change the IR radiation that reaches it. It is powered by 12 V and connected to the mic input of a XO1. When the sensor is activated, the program emits a 1000 Hz tone and displays a photograph of the moving hot body that triggered the alarm.
The pyroelectric sensor or Passive Infrared Sensor (PIR) is activated when you change the IR radiation that reaches it. It is powered by 12 V and connected to the mic input of a XO1. When the sensor is activated, the program emits a 1000 Hz tone and displays a photograph of the moving hot body that triggered the alarm.
The PIR sensor needs a supply of 9V minimum, its output is relay NC (normally closed R=0 ohms)
The PIR sensor needs a supply of 9V minimum, its output is relay NC (normally closed R=0 ohms, open circuit when triggered)
[[File:PIRsensor.jpg]] [[File:PIRsensorconnections.jpg]]
[[File:PIRsensor.jpg]] [[File:PIRsensorconnections.jpg]]