Changes

Logo procedures can include commands to capture data and store it on-board until uploaded to the XO. This can be done on the "Data Upload" tab (shown below) by clicking on the "Start" button (top left). The adjacent progress-bar and upload-count will update as data is uploaded. The data will be displayed in the "Recorded Data" section after the upload completes. Data can be displayed in Table or Graph format. In Table format the data can be formatted across a number of columns, which is required when data from more than one sensor/ source is interleaved. A sensor "type" can be selected to display the name & units and to apply calibration to for each column (see next section for how this information is created). Sensor Names & Units are used to display column headers. Name and Unit can be on the same line ("Name (Units)") or split on their own line (a two-line header). Data can be saved in Comma-Separated-Variables (CSV) format along with one/two headers (if selected).

Logo procedures can include commands to capture data and store it on-board until uploaded to the XO. This can be done on the "Data Upload" tab (shown below) by clicking on the "Start" button (top left). The adjacent progress-bar and upload-count will update as data is uploaded. The data will be displayed in the "Recorded Data" section after the upload completes. Data can be displayed in Table or Graph format. In Table format the data can be formatted across a number of columns, which is required when data from more than one sensor/ source is interleaved. A sensor "type" can be selected to display the name & units and to apply calibration to each column (see next section for how this information is created). Sensor Names & Units are used to display column headers. Name and Unit can be on the same line ("Name (Units)") or split on their own line (a two-line header). Data can be saved in Comma-Separated-Variables (CSV) format along with one/two lines of header (if "Headers" check-box is selected).