Talk:Sugar on a Stick/ZyX-LiveInstaller
Jump to navigation
Jump to search
alternative instructions
To use the ZyX-LiveInstaller:
1. Boot your target computer with Sugar-on-a-Stick;
2. Check that you have room on the target machine:
- Start the Terminal activity;
- Type in
su -c gparted - You will need at least a single partition for the root filesystem that is greater than 2GB. (Some disks labeled and sold as 2GB may not be quite large enough.)
- Optionally create a separate partition for the /boot filesystem, at least 42MB in size
- Optionally create a separate partition for swap space, typically 1 to 2 times the size of the RAM in your system. This will allow the use of hibernation (suspend-to-disk, via pm-hibernate command run from root terminal shell).
- Note: formatting in the partitioner is not required;
- Exit the partitioner by hitting the X in the top corner of window.
3. Run ZyX-LiveInstaller:
- While still in the Terminal activity type in
zyx-liveinstaller; - Read and follow the simple wizard, choosing destination volumes/partitions for root, boot, and swap.
- While still in the Terminal activity type in
Notes:
- This is a destructive install: The contents of the disks or partitions you choose will be overwritten entirely;
- During installation, you are free to use other activities;
- After installation completes, you may remove the LiveUSB or LiveCD, and continue using the newly installed system without rebooting! This means that anything done with the system before, during, or after installation persists into the installed system;
For more information, see the upstream project website [1].